Publicidad
Idiomas disponibles
Idiomas disponibles
GB
OPTIONS SELECTOR
OPTION 1 - Functioning mode
ON :
Zone . The user access relays can be programmed
OFF:
Normal, each user can access all the relays.
OPTION 2 - Alarm
ON :
Relay No. 5 functions as an anti-panic alarm if a
transmitter is activated for over 5 seconds.
OFF :
Relay No. 5 functions normally.
OPTION 3 - Automatic programming
ON :
When programming, after a successful programming the
central unit shows the next free position to program.
OFF :
When programming, after a successful programming the
central unit siplays the programmed transmitter position.
Instruction Manual
( CPLUS2000 )
CHARACTERISTICS
Central access control unit for 2,000 users, with relay activated by radio transmitters, or by proximity cards.
Connection of up to 4 proximity readers in parallel.
2 relays on the main board for 2 accesses, 3 extra relays available, with the possibility of using the fifth relay as an alarm output.
All the relays can be programmed pulse or step by step.
Computer connection is available to monitor inputs and outputs, saving and recovering memory.
Battery connection, without card, ensures that equipment will work without main power supply.
·10 Amp output relays, suitable for connecting an electro-lock.
Possibility to connect antipassback card.
Easily programming for new users, using a keyboard and LCD display.
Possibility of erasing transmitter individually.
Possibility of store RF transmitter.
Possibility of programming transmitters or keys in zone mode. Access relays can be selective.
Possibility of connecting an input/output extension to increase the number of accesses.
INSTALLATION
Before proceeding with installation, ensure that the power supply is disconnected.
In the case of 12 V battery connection, ensure that polarity connection of 3 positive and 4 negative terminals is correct.
The central unit only functions with transmitters and proximity keys.
PASSWORD INPUT
Pressing 'PROG' key activates a long accustic signal. 0000 appears on the display as an access code.
The symbol * appears above the active digit (which can be moved with the 'increase' and 'decrease' keys),
At the top right of the display the number of password is indicated.
3 attempts are available in 30 seconds. If you fail, the central unit is blocked for 2 minutes.
Choose the access code until the correct password is obtained and then press the 'Enter' key.
If the access code is correct, the programming phase begins and memory position 1 is displayed.
CODE PROGRAMMING
Use the 'increase', 'decrease' and 'quick increase' keys to access the memory position from 1 to 2000.
To register a transmitter, go to the free position you wish to occupy and then press the control. When the transmitter is saved, an accustic signal
will be heard. If the I3 switch is OFF, the saved code is displayed, if the I3 is ON, it moves on to the next free memory position.
To de-register a transmitter, go to the position and press the 'C' key.
To exit programming, press the 'FUN' key.
The ER 3 message indicates that the position you wish to program is occupied.
The ER 4 message indicates that the transmitter you wish to program is registered in another position.
If you wish to re-enter programming mode, and less than 5 minutes have gone by since the last programming, the central unit will ask for a
password.
Page 1 - 2
Publicidad
