Black Max BM151333 Manual Del Operador página 17

 Turn off the pressure washer and shut off the water sup-
ply. Pull trigger to release water pressure.
 Engage the lock-out on the trigger handle.
 Push the spray wand into place in the trigger handle.
Rotate clockwise to secure.
To disconnect a nozzle from the trigger handle once
the cleaning job is complete:
 Turn off the pressure washer and shut off the water sup-
ply. Pull trigger to release water pressure.
 Push in on the spray wand and rotate counterclockwise
to remove.
VARIABLE FAN SPRAY WAND
The variable fan spray wand can be used to create differ-
ent spray patterns, from a full fan spray to a direct stream
spray.
When using the fan spray, begin with the lowest pressure
and adjust to higher pressure, spraying far enough from the
material being cleaned to avoid damaging the surface.
OPERATING THE PRESSURE WASHER
See Figure 14.
Use only detergents designed for pressure washers. Many
detergents may require mixing prior to use. Prepare cleaning
solution as instructed on the solution bottle.
To clean:
 Pour detergent in the detergent tank.
 Install the variable fan spray wand.
 Apply detergent at low pressure (- setting on the spray
nozzle).
OPERATION
 Start the pressure washer and spray the detergent on
a dry surface using long, even, overlapping strokes. To
prevent streaking, do not allow detergent to dry on the
surface.
To rinse:
 Using the variable fan spray wand, adjust the spray to
the high pressure setting (+).
NOTE: The pressure washer does not dispense detergent
when on the high-pressure setting.
 Spray away from the rinsing surface for approximately 10
seconds to allow any remaining detergent to be flushed
from the line.
 Start at the top of the area to be rinsed and work down,
overlapping the strokes.
MOVING THE PRESSURE WASHER
To move the pressure washer:
 Turn the pressure washer off. Point nozzle in a safe direc-
tion and pull trigger to release water pressure.
 Tilt the machine toward you until it balances on the
wheels then roll the machine to the desired position.
Page 13 — English