Prince Castle TX-230ECE Manual Del Operador página 5

6
Release the upper and lower locking latches from the conveyor
rollers.
Upper Latch
Remove the conveyor belt.
7
Rotate the belt while removing
it from the side of the unit.
TX-230ECE 537-530
8
9
The conveyor belt has only one
contact surface and must be
re-installed with orange side facing
out.
The Teflon sheet uses both sides
as the contact surface. When
re-installing, rotate the usage by
Lower Latch
turning top-to-bottom and/or
turning the sheet inside/out.
10
When reassembling convey-
or belt, make sure plastic
spline is positioned correctly
as shown.
When reassembling release
sheet, be sure to install upper
and lower retaining bars in
the correct end.
5
Remove the plastic spline from the belt.
Place the belt and Teflon sheet on a flat surface. Clean
belt and sheet with CAPITAL multi-purpose cleaner,
acceptable for use on food contact surfaces.
Reassemble the unit by reversing steps 1 - 8.
Release Sheet
Upper Retaining Bar
Printed in USA 0320 © 2003
TOASTER
TX-230ECE
Release Sheet
Lower Retaining Bar