Optimus MT-PU Guía Rápida página 2

QUICK GUIDE
SPECIFICATIONS AND CONNECTIONS
Unscrew the 12 screws from the back of the PU-10
speaker for removing the metal plate.
Remove the filter circuit supplied with the speaker,
reference P2-144112 (PAL).
Once MT-PU transformer and filter circuit
C2-144112 (C-MARK) are installed,
connect again the 2 pairs to the tweeter (+ - TW)
and to the woofer (+ - WF).
Installation guide Version 1.1
At WARNING:
Disconnect the 2 pairs of cables specified above: 2 for
woofer (red and black) and 2 for tweeter (yellow and black).
Install the transformer and new filter circuit C2-144112
(C-MARK) supplied with the transformer at the same place of
the previous circuit. Use the 4 screws to fix the circuit and
Assembly the circuit + transformer module into the PU-10
speaker and screw on the 12 screws to fix the metal plate.
1/1
MT-PU TRANSFORMER INSTALLATION IN THE
MT-PU
Make sure the amplifier power outlet conforms to the
power requirements before connecting the equipment.
Do not install the unit near heat sources.
Only qualified service personnel should be allowed to
install and operate the unit.
1 M8 screw for the transformer.
PU-10 SPEAKER