Troubleshooting - ORFELD B08 Instrucciones De Uso

Clean the hard brush roller (15) in the same way.

8. Troubleshooting

To reduce the risk of shock and unintended operation, turn off power and remove battery
pack before servicing.
Problem
Vacuum not pick up debris
Brush roller not spin
Poor suction
Vacuum suddenly turns off on
its own
Vacuum won't turn ON or
charge
Short running time
In any other case or if the solution explained above did not solve the problem, please
contact us at support@orfeldtech.com.
Possible cause
1. Dustbin is full
2. Filters clogged or dirty
3. Filters are out of service
Brush roller clogged by hair,
fibers, etc.
1. Dustbin not seated
completely
2. Filters clogged or dirty
3. Dustbin not installed
correctly
4. Low battery
5. Nozzle or dirt passage
clogged
1. Dustbin is full
2. Filters clogged or dirty
3. Vacuum overheat
1. Low battery
2. Vacuum overheat
1. Low power
2. Filters clogged or dirty
23
Possible solution
1. Empty the dustbin
2. Clean the filters
3. Change the worn filters
Clean the brush roller
1. Reinstall the dustbin.
Make sure lid is closed
completely
2. Clean the filters
3. Reinstall the dustbin
4. Fully charge the battery
5. Disconnect nozzle to
remove debris
1. Empty the dustbin
2. Clean the filters
3. Let vacuum cool down and
retry
1. Fully charge the battery
2. Let vacuum cool down and
retry
1. Fully charge the battery
2. Clean the filters