wigam LOVAIR PRO Manual De Uso página 19

4.2 USE WITH HVAC SYSTEMS
1. Place LOVAIR PRO
2. If there is an air conditioner, a fan coil or a fan, activate the ventilation system at
the maximum power.
3. Close all windows and possible air inlets with the outside.
4. Connect the unit to the power supply.
5. Select the functioning time suitable to the room/place you want to treat
(please see following table).
To start the operation, it is necessary to turn the selector clockwise until the red light turns
on; at this point, turn the selector anticlockwise until the desired t*ime is reached.
Surfaces ip to (*)
(*) Recommended data assuming a room height of 3m.
(**) For bigger surfaces it is possible to use 2 appliances located at the ends of the environment to be treated.
The operator must leave the room/place as soon as the ozone generator has been activated.
Nobody (persons or animals) must stay in the room/place during the treatment.
6. Close the room/place by isolating it.
7. Clearly signal that treatment has been initiated so that no one can accidentally enter
inside the room/place.
8. The unit will stop automatically when the selected time is over.
9. It is recommended to wait another 10-30 minutes, before aerating the work area, in
order to maximize the bactericidal effect.
10. Open all doors or windows to ventilate the treated environment for at least 40 minutes.
Ventilate the treated environment (room/place) for at least 40 minutes
on a solid and level surface, following the directions given in section 3.
IMPORTANT
15 m
2
30 m
2
50 m
2
65 m
2
80 m
2
WARNING
WARNING
WARNING
before entering it again.
19
USER'S MANUAL
Time in minutes (**)
15'÷30'
30'÷60'
60'÷90'
90'÷120'
120'÷180'
LOVAIR PRO