Kenwood CX-DAB1 Manual De Instalación página 5

Match the protrusion of the amplifier B
7
with the 5 on the antenna film A and
paste.
■
Do not touch the feeder terminal or the
pasting surface (adhesive side) of the
amplifier.
When installing the antenna on the
right side
Match the protrusion with 5
Antenna film A
When installing the antenna on the left
side
Amplifier B
Earth sheet
Match the protrusion with 5
Remove the film covering the earth
8
sheet and paste the earth sheet on the
metal part of the vehicle.
Provide sufficient leeway for the earth
sheet so that it does not interfere with the
interior parts (front pillar cover).
Also take care that the interior parts do not
interfere with the amplifier B.
Amplifier B
Earth sheet
Amplifier B
Antenna film A
Front glass
Front pillar
Interior part
Earth sheet
Wire the antenna cables.
9
Use cord clamper C to secure the
■
antenna to the pillar at several locations.
Notes
Take the following precautions when
passing the antenna cable inside the front
pillar where the air bag is installed.
Install the amplifier part of the antenna
–
cable in front or above the air bag so
that the antenna and the air bag do not
interfere.
Amplifier B
The front pillar cover is secured with
–
a special clip which may need to be
replaced when the front pillar cover is
removed.
Contact your vehicle dealer for details
on replacing the front pillar cover and
availability of replacement parts.
Interior part
Select the DAB antenna power is set to
10
"ON"
■
You cannot receive DAB or DAB reception
is poor when DAB antenna power is set
to "OFF".
■
For details, see the your control unit
instruction manual.
Air bag
Front pillar
Clip
|
English
5