CDVI SOLARPW Manual De Instrucciones página 11

INSTALLATION MANUAL
SOLARPW-SOLARPB-STARPW-STARPB
Wiegand 125 kHz Proximity Readers
Ref: STARPW-STARPB
1
1 Measure and mark the center lines to determine the
reader position. Drill the fixing screw holes (Diameter:
5mm). Drill the wiring access area (Diameter: 15mm).
3
3
Insert the plastic plugs in the mounting holes, connect the cable (refer to wiring diagram on page 11), then fasten
the reader with the TORX
(refer to page 8 "Reminders and recommendations").
screw using the TORX
® ®
Foam seal
2
fig. a
2 Place the foam seal at the back of the reader. Take
care to begin from the bottom. (Sch. a). The foam seal
must be visible (about 2mm) on the top-back of the rea-
der (Sch. b).
bit (Sch. c). Make sure that the varistor is connected on the lock
Sch. b
Sch. a
Sch. c
cdvigroup.com
EN
11