Using The Timer; Cleaning, Care And Maintenance - Buffalo GH160 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)

Using the Timer

The digital timer with audible alarm can be set from 1 second to 15 minutes
The timer provides an audible alarm, after the set time expires the unit will NOT switch off.
START/STOP : Press START/STOP to start timer, press again to stop. The timer will provide an audible
alarm after the set time. The alarm will beep 10 times and the display will continue to flash until timer is
reset (press START/STOP button)
UP : Press UP to add extra time
DOWN : Press DOWN to reduce time
PROGRAM : There are a total of 6 programmable timer settings. The default factory program settings
are given below
Program 1
Factor
Preset 00:30
Time
To change the length of a program select the program you want to change by scrolling using the
PROGRAM button. Adjust the program time by using the UP and DOWN buttons. Press START/STOP
to commence the countdown. The new program time will be automatically stored.
If the unit is left without power for more than 24hrs the timer settings will revert to the factory
defaults

Cleaning, Care and Maintenance

The Pasta Cooker should be cleaned after each day's operation, however it may require cleaning more
often, depending on the volume of use.
1. Switch off the power and disconnect from the power supply, removing the plug from the socket.
2. The Pasta Cooker must be left to cool before cleaning.
3. Flush clean water through the drain tube after use
The control box cannot be immersed in water, but can be wiped down with a damp cloth.
2 3
01:00 01:30
4 5
02:00 02:30
6
03:00
UK