Wall-Mounting Installation - Haverhill HHE1500M1 Manual De Uso Y Cuidado

Wall-Mounted Installation
1� The mounting location should be at least 6 inches (15cm) above the floor and 20 inches (50cm)
below the ceiling�
2� Prior to drilling, locate the studs behind the drywall and measure out the distance for the 4
holes. The diameter and depth of the holes should be 8mm and 35mm, respectively. You can
find the distance between the 4 holes using the diagram below. Ensure the alignment is
leveled and double-check the measurements with the distance between the 2 slots near the
back handles from the rear of the heater� Use a power drill to create the 4 holes into the wall�
0�94"
24 mm
3� Insert the plastic drywall anchors into the drilled holes�
Fasten the screws through the wall-mounting hooks
and through the openings of the drywall anchors�
Adjust and tighten the wall-mounting hooks onto
the wall. Affix the 2 rubber pads onto the back of the
heater using the 2 smaller screws�
4� Locate the 2 slots from the rear of the heater and affix
them onto the wall-mounting hooks on the wall. Do
this by aligning the 2 slots from the rear of the heater
above the respective wall-mounting hooks. Move the
heater downward until the wall-mounting hooks slide
through the slots, then shift the heater to the left
so that the slots lock into place with the respective
hooks. Once the hooks are locked into place, carefully
lower the heater. Ensure the heater is stable and
securely mounted to the wall�
NOTE: DO NOT affix the feet and handles to the heater
when using the wall-mount installation. The feet and handles
are used for freestanding installation only.
Wall-Mounting Hook
19�88"
505 mm
7
0�94"
24 mm
a b c
Rear of the Heater
d e
a. Slot for Wall-Mounting Hook
b. Screws for Wall-Mounting Hook
c. Wall-Mounting Hook
d� Rubber Pad
e� Small Screw