Technical Data; Guarantee - AEG SLS 4706 Instrucciones De Servicio

When the remote control is used, care should be taken that
there are no objects between the remote control and the central
loudspeaker (e.g. table, chair, etc.). These objects prevent the
infrared beam of the remote control from reaching the receiver
of the central loudspeaker. It is then not possible to control the
television with the remote control.
Buttons on the Remote Control
and Front Panel
1. MASTER +/-
Buttons for volume adjustment.
2. 5.1/2.1
Switches between 5.1 (AC3/DTS), 2.1 and A5.1.
3. SUBWOOFER +/-
With these buttons you can set the volume of the subwoofer.
4. SURROUND +/-
With these buttons you can set the volume of the surround
loudspeakers.
5. CENTER +/-
With these buttons you can set the volume of the centre
loudspeaker.
6. ST.BY
STANDBY switch ON/OFF.
Switches the system to the standby mode.
POWER Switch
With this switch the system can be switched on and off.
7. MUTE
With this button you can switch off the loudspeakers without
changing the volume.
NOTE:
When switching off this function ensure that the overall
volume is not set to maximum!
8. MEMO 1-2-3
For selection of three preset volume levels.
NOTE: These preset values cannot be changed.
34
05-SLS 4706 34
9. FRONT +/-
These buttons are used to adjust the volume of the front
loudspeakers.
NOTE:
Some buttons are located both on the front panel of the
device and on the remote control. The buttons with the
same designation have the same function.
Initial Operation
Insert the plug in a duly installed 230V/50Hz socket.
1. Switch on your sound source (e.g. DVD player) and start it.
2. Switch on the subwoofer with the on/off switch on the front
of the device.
3. Use the 5.1/2.1 button to select the desired input source.
4. With the MASTER +/- button you can set the overall volume.
5. By pressing buttons 3 - 5 / 9 you can adjust the volume of
the central, front, surround and subwoofer loudspeakers.
NOTE:
Please note! The surround and centre loudspeakers can
only be controlled during 5.1 operation.
6. To stop operation, turn off the subwoofer with the on/off
switch.

Technical Data

Model: ........................................................................ SLS 4706
Power supply: ........................................................ 230 V, 50 Hz
Power outputs
L, R, C, LS, RS: ......................................... 5 x 80 W PMPO
Subwoofer: ..................................................... 100 W PMPO
This device has been tested according to all relevant current
CE guidelines, such as electromagnetic compatibility and low
voltage directives, and has been constructed in accordance with
the latest safety regulations.
Subject to technical changes without prior notice!

Guarantee

The device supplied by our Company is covered by a 24 month
guarantee starting on the date of purchase (receipt).
During the life of the guarantee any fault of the device or its
accessories ascribable to material or manufacturing defects will
be eliminated free of charge by repairing or, at our discretion, by
replacing it. The guarantee services do not entail an extension
of the life of the guarantee nor do they give rise to any right to a
new guarantee!
Proof of the guarantee is provided by the proof of purchase.
Without proof of purchase no free replacement or repair will be
carried out.
09.05.2007, 12:21:47 Uhr