Operating Instructions - Magic Chef MCCCB24A Manual Del Usuario

OPERATING INSTRUCTIONS

Before operation, please read the user's manual carefully. If the appliance has been immersed in water, please
stop using and call the technicians to check and repair or replace all the components that are immersed in the
water. Dry the wet burners before using. Before using, please make sure that the main burner, pilot light burner
and oil receiver are in correct installation.
1. Before igniting the pilot light, ensure there is no gas odor around the device. When first using or after
cutting off the gas supply, it may take several minutes to ignite the pilot light due to the air existing in the
pipeline or clearance of the inlet pipe.
2. The pilot light should be ignited manually. Remove the grate and rotate all the control knobs to the full
open position. The pilot light is near the burner, which can be reached from the top of the burner. Make
sure that the gas shut-off valve is on and the air in the pipeline is cleared. After turning on the gas valve,
ignite the pilot light with a match or igniter, DO NOT use lighter. Then re-install the grate.
3. After using, please turn off the main gas supply, all burner knobs and the pilot light.
4. The control knobs of this device have a continuous setting range from "ON" to "OFF". Rotate the knob to
the "ON" position to ignite the burner until all parts of the burner become lit. Then set the control knob to
the desired position. The set value can be adjusted freely at any time.
NOTE: Control knobs of the burners can be operated manually only. DO NOT rotate it with tools. If it
cannot be rotated manually, DO NOT rotate or repair it with force. Force or improper maintenance may
cause fire or explosion.
5. If you are not going to use the appliance, please turn off the control knobs to save energy. The gas burner
can provide a large quantity of heat, therefore, DO NOT keep the appliance on if it is used intermittently.
6. To reduce the amount of grease touching
the heat radiant plate, lift the grate
slightly. Place the hook at the rear of the
grate on the bottom shelf and incline
front of the grate.
ADJUSTING THE PILOT LIGHT
1. Remove all the control knobs, front panel and grates.
2. Rotate the screw clockwise with a small straight screwdriver to reduce the flame and rotate it
counterclockwise to increase the flame.
3. Adjust the height of the pilot light to ¼ ". Have an operating test: All parts of the burner should be ignited
immediately without any delay. A larger flame may be needed in a well ventilated room to keep the pilot
light burning.
4. Before using, install the grate, front panel and all the knobs back.
NOTE: There may be some smoke at the initial startup as the result of rust prevention coatings burning off.
This is normal. Please allow at least a 15 minute burn in period before using for the first time.
10
Figure 2