Power And Battery Use; Checking The Battery Status; Charging The Clearreader + Battery; Extending The Battery Life - Optelec ClearReader+ Manual Del Usuario

Optelec

6. Power and battery use

Checking the battery status

Press the Back and Forward buttons together to check the battery status. The ClearReader
announce the status in percentage, where 100% means a fully charged battery. If the battery is
low, please charge the battery with the dedicated power supply.
Charging the ClearReader
To charge the ClearReader
rear side of the unit. Plug the power cord into a power outlet.
Charging the ClearReader
operate for approximately 5 hours. Please note that, for safety reasons, only the power supply
supplied by Optelec should be used to charge the ClearReader

Extending the battery life

To ensure the battery pack maintains maximum capacity, disconnect the ClearReader
power source at least once a month and operate it on battery power until the battery pack is
empty.
English
+
battery
+
, connect the power supply to the power connector located at the
+
takes approximately 3 hours. A fully charged ClearReader
ClearReader
+
.
+
+
will
+
can
+
from the
56