How To Clean The Nozzle Hose - Carpet Pro CPU-3QD Manual Del Usuario

HOW TO CLEAN THE NOZZLE HOSE

CAUTION: Unplug the vacuum cleaner
before performing any of these steps.
The nozzle hose carries the dirt from the
nozzle to the vacuum bag. If the hose
should become clogged:
Model: CPU-3QD
1. Remove the wand from the wand/hose
holder.
2. Squeeze the tabs on both sides of the
quick clean-out port and pull away
from the vacuum (Fig. 1).
3. Check above and below the port
opening for obstructions.
4. Remove any obstructions.
5. Replace the quick clean-out port by
squeezing both tabs and pushing the
hose back into the wand/hose holder.
Replace the wand.
Models: CPU-3N and CPU-4N
1. Pull out and turn the lid of the accessory
attachment opening. Remove the clog
or blockage (Fig. 2).
Model: CPU-4T
1. Pull out and turn the lid of the accessory
attachment opening. Remove the clog
or blockage (Fig. 2).
2. If the above step is not enough, remove
hose cuff from the attachment port
inlet (Fig. 3). If you haven't located the
clog, turn the vacuum cleaner over
and remove the bottom plate. Check
nozzle inlet tube for obstructions
(Fig. 4). Clear tube and reinstall the
bottom plate.
12
Fig. 1
Fig. 2
Fig. 3
Fig. 4