Kenmore 580.74121 Manual Del Propietário página 7

_J Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
closest to the selected position using screw (ITEM E).
_1 Place the sill supports with the cabinet on the
window sill's selected position (FIG. 10).
ITEME ,1
Lowe_gulde s_. "'_ ,
Ca_net
,,o.,o
[]The cabinet should be installed with a very
slight tilt (about 1/4") downward to the outside
(FIG, 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
_1 Attach the L BRACKET (ITEM J) with screw
(ITEM G). (FIG. 14)
_ FIG. 14
[] DRAINAGE
Be sure to insert the drain pipe into base pan before
installation.
The air conditioner must be installed with a slight tilt
downward to the outside for proper water drainage.
The air conditioner will drain the excess condensed
water through the drain pipe. (FIG. 15)
DRAIN PiPE
FIG. 11
FIG. 15
]Slide the chassisintothe cabinet. (FIG. 16)
CAUTION: Forsecuritypurposes,reinstall s ide
screwsyou removedin step 1.
_ Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front angle into the
window inner sill (FIG. 12).
ITEM B
Track
Lower Guide
ITEM F
FIG. 12
]Pull each side curtain fully to each side of
window opening.
Attach each side curtain to the window sash using
screws (ITEM G). (FIG. 13)
Screw
Screw FIG. 16
]Cut the foam seal (ITEM H) to the proper length
and insert between the upper window sash and the
lower window sash. (FIG. 17)
FIG. 17
_The vent control handle must be straightened
before the decorative front is attached.
__3 Pull down part (_)to align with part _).
,. Part
FIG. 18
-7-