Bosch TS2000 Instrucciones De Funcionamiento Y Seguridad página 8

BM 2610013454 06-10.qxp:BM 2610013454 06-10.qxp 6/1/10 10:36 AM Page 8
Step 6
Attach Linkage Bars
1. Align hole in upper linkage bar with hole in
top tube bar as shown in figure G.
2. Place one (1) flat washer onto one (1) 10
mm x 100 mm bolt.
3. Insert bolt through linkage bar and place
another (1) flat washer on bolt between top
tube bar and upper cross bar.
4. Insert bolt through top tube bar, place one
(1) flat washer, and loosely tighten with
one (1) 10 mm lock nut.
Note: Do not over-tighten lock nut - these
parts need to freely rotate for stand to
operate properly.
Repeat this procedure on opposite side.
For Mounting Bosch 4100/4000
Table Saw to Stand
1. Using the diagram on page 9 (figure C),
locate the Bosch 4100/4000 mounting
holes and position saw on stand as shown
in figure B.
2. To mount the 4100 Table Saw:
Align the saw as shown in figure A. Place
one (1) 6 mm flat washer onto one (1) 6
mm x 90 mm hex head bolt and insert bolt
through mounting hole in table saw and
through stand table top.
To mount the 4000 Table Saw:
Align the saw as shown in figure B. Place
one (1) 6 mm flat washer onto one (1) 6
mm x 75 mm hex head bolt and insert bolt
through mounting hole in table saw and
through stand table top.
3. Place one (1) 6 mm flat washer and
securely tighten with one (1) 6 mm lock
nut.
Repeat this procedure on the three remaining
mounting holes.
For Mounting Table Saw to Stand
FIG. G
Lock Nut Top Tube
Bar
Washer
-8-
Linkage Bolt
Bar
Washer Washer
FIG.