Quarkpro FS-3000D Manual De Usuario página 3

TO INSTALL THE MOUNTING BRACKET
1.- Place the fixture face down on a table
2.- Place a plastic washer on each mounting bracket stud
3.- Place one end of the bracket on one of the mounting studs. Bend the other end of
the mounting bracket open slightly and work it onto the opposite stud
4.- Place a hand knob on each stud. Tighten both hand knobs to lock the mounting
bracket in place
DMX OPERATION
DMX connection
The FS-3000D provides both 3-pin and 5-pin XLR sockets for data connection. The
pin-out on all sockets is pin 1 to shield, pin 2 to cold (-), and pin 3 to hot (+). There is no
connection to pins 4 and 5. The sockets are wired in parallel: both inputs connect to
both outputs. For reliable data transmission use one input and one output!
DMX link
1. Connect the DMX data input from the controller to the FS-3000D´s 3-pin or 5-pin
input (male) socket.
2. You can connect up to 31 additional fixtures output-to-input.
3. Insert a termination plug in the output of the last fixture on the link.
EN 2