Troubleshooting; Control Guide; Temperature Control - Global Industrial 256551 Manual Del Usuario

5

Troubleshooting

Problem
When Power Switch
lamp is not working
When heater switch
lamp is not working
When heater is not
working
• After identifying and fixing the problem, always turn the power off and on again to re-operate.
6

Control Guide

Power ON
ON/OFF switch for main power at OFF, both fan and heater will be turned off. If protective sensors
(overheat sensor, tilt motion sensor) detects hazards. Heater will get shut off automatically. After
identifying and solving the problem, re-start the heater.

Temperature Control

Turn the control knob clockwise to desired temperature. The heater will operate until the set temperature
is reached, then turn on. Note: The heater will turn back on automatically to maintain the desired
temperature.
Heat ON
ON/OFF switch for the heater
Portable Electric Heater
• Check the main power connection (check main terminal.
• Check if the heater is tilted.
• Temperature sensor detects heater overheating during operation. (Check whether fan is
working)
• If fan is not working, check for shorted wire
• Check for shorted wire
• Check for shorted wires (restart after inspection)
• OCR (Over Current Relay) is on due to overload (Restart after pressing reset button)
Caution
Shut-off Instruction
• You must follow these instructions to turn off the
machine to PREVENT FIRE HAZARDS
1. Turn off green switch (Heater)
2. Wait for 3-4 minutes for unit to cool down
3. Turn off red switch (Power and fan)
Solution
5