6.
Once handle is in place, shake back and forth to make sure the handle can
not come out when carrying unit as vacuum head may pivot over and fall if
the bucket is empty.
CAUTION: Use of a bucket that is not equipped with a handle can result in unintended
spillage of the bucket s contents, damage to the vacuum head and/or operator injury.
7.
Connect the hose to the vacuum intake by securely pushing the hose cuff
with the protrusions into the intake. Push the pick-up tool securely into the
smooth hose cuff.
8.
Cord Storage - Coil cord around head and snap plug to cord.
OPERATION DRY PICKUP
TANK/FILTER SETUP
NOTE: Be sure filter is in place for dry pickup. See FIGURE 2.
IMPORTANT NOTES
Do not remove, substitute, bypass or change the filter in any way.
Use only SpeedClean lters use of other lters will void the warranty and may
not provide proper filtration.
1. Secure vacuum head on suitable bucket.
2. Snap and secure handle in holders.
Caution: Securing handle may create a pinch hazard between handle and holders.
3.
Ensure the vacuum control switch is in the Vacuum Dry setting. See
FIGURE 4 below and on vacuum head.
4. Ready for vacuuming.
September 2010
FIGURE 1
6