Cleaning And Storage - JOCCA 9072 Manual De Instrucciones

12-EN
-Keep the appliance and its cable out of reach of the children
younger 8 years old.
-Children should be supervised to ensure they do not play with
the device.
-Before connecting the device to the mains or the car connection
make sure the cable and plug are in perfect condition, also check
that the voltage on the device is valid for electrical installation.
-If you detect that the power cable or plug are damaged, do not
use the device and do not try to replace the cable. Go directly
to the authorized service JOCCA where it will be replaced
properly.
-Do not let the power supply cable touch or come near the hot
parts of the appliance.
-Do not immerse the appliance or any part of it in water or
anyother liquid.
-Do not pull the cable to unplug the appliance from the mains,
always pull from the plug.
-If your appliance has been dropped or fallen into water or
anyother liquid do not use it or try to repair it. Take it to the
JOCCA technical service.
-Use this appliance on a flat, straight and horizontal surface.
-Leave a 10 cm space behind the appliance and 2 cm at the
sides for air circulation.
-Do not place heavy objects on the appliance.
-The proper functioning of the device will depend on the
room temperature. A room temperature lower than 25ºC is
recommended.
-The minimum temperature that this appliance can reach will
depend on the ambient temperature, and will reach around
16ºC below ambient temperature.
-It is not recommended the use of adaptors, plugs and/or
extension cables.
-Installation by a technician is not necessary. Use the device in
avertical position.
-This fridge is aimed to cool wine so do not put any kind of food
inside it.
INSTRUCTIONS FOR USE
-Before using the appliance for the first time, or if it has not
beenused for a long time, please clean with a damp cloth and
leave todry, set the temperature to minimum and let the cooler
workempty (without and products inside) for at least two hours,
after wards put bottles into the cooler and set the required
temperature.
-Plug in the appliance to the mains electricity supply.
-Select the required temperature by using the temperature
adjustment buttons, the selected temperature will blink during
a fewseconds, then the display will mark the real temperature
of thewine celar and progressively will reach the selected
temperature.
-To use the inside light the cooler has a switch which will allow
you to switch it on or off. To turn the light on press the switch and
to turn it off press the switch again.
-Place your bottles of wine in the removable trays.

CLEANING AND STORAGE

-Before cleaning the fridge, make sure the device is not pluggedin
the current and clean it first.
-Empty the fridge previously for easy cleaning.
-Clean its inside with a water and bicarbonate solution. After
that, clear with clean water.
-Clean the fridge regularly.
-Never use abrasive detergents or damage products in the
device.
-NEVER PUT THE DEVICE INTO WATER OR ANY OTHER LIQUID.
EN-13