Fagor PRES-05 Manual De Instrucciones página 19

extracted, press the open door
button (.), open the door and
take out the barrel with the tubing
connected.
• Disconnect the inlet (8) and outlet
(.3) tubing by pressing the relevant
white button whilst pulling the tubes.
• Empty out the remaining gas by
inserting the escape valve (0) into
each adaptor (fig. P).
• Remove the adaptor from the barrel.
• You must now clean the dispenser.
There are 2 ways of cleaning the dispenser:
1. - Fill the mini cleaner (5) with hot water
and a little detergent.
- Insert the mini cleaner (5) into the
outlet tubing (fig. R). Whilst pulling the
tap handle (2) towards you, press the
mini cleaner at intervals several times.
The pressure will force the soapy water
through the system.
- Repeat the same operation again just
with water, without detergent of any kind.
1. If you have purchased the optional
Fagor CO accessories, you can clean the
2
dispenser () as follows:
- Fill the cleaning bottle () halfway with
hot water and a little detergent.
- Insert the standard barrel adaptor
(2) into the cleaning bottle () and
connect the inlet tubing (8) to the
adaptor pin (2.3) and the outlet tubing
(.4) to the adaptor socket (2.2) (fig.
Q).
- Turn the regulating valve knob (3.)
clockwise.
- Pull the tap handle (2) towards you and
let the soapy water pass through the
system for around 5 seconds.
- Repeat the same operation again just
with water, without detergent of any
kind.
If you have a pressurised keg compatible
with the Fagor dispenser, proceed as
follows:
1. Move the side compartment cover (.4)
of the dispenser downwards and remove
the cover.
2. Extract the CO
unit and turn the
2
regulating valve tap (3.) anti-clockwise
to close it completely.
3. Place a recipient under the tap (.6)
and pull the tap handle (2) towards you.
Beer will be dispensed until the barrel is
completely empty.
4. You can now proceed with the following
instructions.
• Once all the beer has been
extracted, press the open door
button (.), open the door and
take out the barrel with the tubing
connected.
• Remove the adaptor from the barrel.
• Disconnect the inlet (.3) and outlet
(.4) tubing by pressing the relevant
white button whilst pulling the tubes.
• You must now clean the dispenser.
To clean the dispenser for this type of keg,
follow the instructions given in point  for
the pressureless cask.
9. INFORMATION FOR THE CORRECT
DISPOSAL OF ELECTRICAL AND
ELECTRONIC APPLIANCES
At the end of its working
life, the product must not be
disposed of as urban waste.
It must be taken to a special
local authority differentiated
waste collection centre or to
a dealer providing this service. Disposing
of a household appliance separately avoids
possible negative consequences for the
environment and health deriving from
inappropriate disposal and enables the
constituent materials to be recovered to
obtain significant savings in energy and
resources.
To remind you that you must collaborate
with a selective collection scheme, the
symbol shown appears on the product
warning you not to dispose of it in
traditional refuse containers.
For further information, contact your local
authority or the shop where you bought the
product.
7