Ega Master 51107 Manual De Instrucciones página 7

The owner and/or operator of this product must have a complete understanding of all wamings
and instructions including inspection and maintenance procedures contained in this manual and
on the product label before using this product. Anyone involved in the use and/or operation of this
device must be careful, competent, and qualified in its safe operation and use.
1. Assemble mast (1) to rear leg (2) using two bolts (5), two bolts (6) and nuts (7) and lock
washers (8) and flat washers (9) as shown.
2. Assemble the cross member (3) to the front leg using two bolts (5), two bolts (6) and nuts (7),
lock washers (8) and flat washers (9) as shown.
3. Assemble wheels (14) to rear leg (2) using shoulder bolts (15) and nuts (16) lock washers (17)
and flat washers (18) as shown.
4. Mount the middle caster (22) to the mast assembly (1) using nut (20) and lock washer (21) as
shown.
5. Assemble locking casters (19) to front leg (4) using nuts (20) and lock washers (21).
6. Assemble crossmember assembly (3,4) to the mast assembly (1) using the shoulder bolt (10)
and nut (11), lock washer (12) and flat washer (13) as shown.
7. Insert head (25) into housing at top of mast (1). fasten using the locking pin (28).
8. Assemble mounting adaptors to the head using bolts (27) and nuts (7) lock washers (8) and flat
washers (9) as shown.
9. Tighten all fasteners and place caps (32) into the leg ends as shown.
Before applying load, lock mounting plate rotating mechanism. Using a hoist, suspend the
engine at a level with the mounting plate. With the mounting arms loose from the mounting plate
(but not removed) bolt the mounting arms to the rear of the engine using the bell housing mounting
bolts (bolts not supplied). Make sure the engine is centered and straight on the mounting plate,
then tighten the mounting arms to the engine, and the mounting anns to t.he mounting plate. After
making sure all connections are tight, SLOWLY lower the hoist, transferring load to the stand. To
remove an engine from the stand, first attach the hoist to the engine using a sling or similar device.
After the hoist and sling are secure to the engine, raise the hoist, taking the load off of the stand.
The mounting bolts can be removed freeing the stand from the engine.
Keep your stand clean and well lubricated. Lubricate all wheel axles with motor oil or light
machine oil and grease the caster swivel bearings once a year or as necessary.
Also applya thin coat of grease to the mounting plate rotating mechanism as necessary, but at
least once a year.
OWNER/OPERATOR RESPONSIBILITY
ASSEMBLY INSTRUCTIONS
OPERATION
MAINTENANCE
7