Tightening Torques; Troubleshooting - Atlas Copco TEX Serie Instrucciones De Seguridad Y De Funcionamiento

Safety and operating instructions

Tightening torques

TEX 09PS
B
F
E
C
TEX 10PS
20
A
C
D
TEX 12PS
Air inlet nipple, use Loctite® 243™ (Loctite is
A.
a registered trademark of Henkel Corporation.
243 is a trademark of Henkel Corporation.)
Handle, 500 Nm for TEX 10PS
B.
C. Nut, 70 Nm
Bushing, use Loctite® 603™ (Loctite is a
D.
registered trademark of Henkel Corporation.
603 is a trademark of Henkel Corporation.)
Nut, 500 Nm
E.
F. Air inlet nipple, 300-350 Nm. use Loctite®
243™.

Troubleshooting

If the pneumatic machine does not start, has low
power or uneven performance, check the following
points.
♦ Check that the insertion tool being used has the
correct shank dimension.
♦ Check that the pneumatic machine is getting the
correct amount of lubricant. Too much lubrication
can cause starting problems, low power or uneven
performance.
♦ Check that the compressed air system supplies
the machine with sufficient air pressure to give full
power.
♦ Check that the dimension and length of the air
hose are according to the recommendations. See
"Installation".
© 2015 Construction Tools PC AB | No. 9800 1386 90c | 2015-10-07
TEX 09PS, 10PS, 12PS
A
C
Original instructions