Quick Start - Samson RTE 2 Manual Del Usuario

Quick Start

Fully charge your RTE 2 Bluetooth Headphones before first use.
1. To charge your headphones plug the included USB cable into the USB port of your computer or a USB 5-volt adapter (smart phone charger) and
plug the smaller end of the cable into the bottom of the right ear cup of your headphones. You will see a green light appear just above the charge
port of your headphones.
2. When the battery is fully charged the green light indicator above the charge port will turn off.
Pairing your headphones to your device for wireless operation via Bluetooth :
1. With the headphones powered off press and hold the Multi-Function button (located next to the charging port on the bottom of the right ear cup)
for 5 seconds.
2. You will hear a quiet tone and the indicator light will flash blue once, then flash red for 3 seconds then you will hear a louder repeating two note
tone and the indicator will repeatedly flash blue. Your headphones have now entered pairing mode.
3. Go into the Bluetooth settings/preferences of your music source and make sure your device is in discoverable mode.
4. In your music source's Bluetooth preferences select "Samson RTE 2"
5. If your device asks for a passkey, enter digits 0000 (four zeros) and press OK.
4
English