How To Clean; Light Bulb Replacement - KENMORE ELITE 363.6369 Serie Guía Para El Uso Y Cuidado

HOW TO CLEAN THE OUTSIDE
We recommend against using cleaners
with ammonia or alcohol, as they can
damage the appearance of the oven.
If you choose to use a common
household cleaner, first apply the
cleaner directly to a clean cloth,
then wipe the soiled area.
Case
Clean the outside with a sudsy cloth.
Rinse and then dry. Wipe the window
clean with a damp cloth.
Glass Door (on some models)
Wipe with a clean damp sponge. Dry
thoroughly. Do not use cleaning sprays,
large amounts of soap and water, abrasives
or sharp objects on the panel--they can
damage it.
Stainless Steel Control Panel and
Door (on some models)
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use
a hot, damp cloth with a mild detergent
suitable for stainless steel surfaces. Use
a clean, hot, damp cloth to remove soap.
Dry with a dry, clean cloth.
If food soil remains, try a general kitchen
cleaner, such as Fantastik_"_Simple Green _''_
or Formula 409_"!
For hard-to-clean soil, use a standard
stainless steel cleaner, such as Bon-Amb _
or Camed"!
Apply cleaner with a damp sponge. Use a
clean, hot, damp cloth to remove cleaner.
Dry with a dry, clean cloth. Always scrub
lightly in the direction of the grain.
After cleaning, use a stainless steel
polish, such as Stainless Steel Magid"_
Revere Copper and Stainless Steel
Cleaner :_or Wenol All Purpose Metal
Polisher Follow the product instructions
for cleaning the stainless steel surface.
Bottom
Clean off the grease and dust on the
bottom often. Use a solution of warm
water and detergent.
Vent Grill
Use warm soapy water and a dishcloth to
wipe off the grill. If desired, use cotton
swabs to get in between the grill louvers.
Door Frame
It's important to keep the area clean
where the door seals against the oven.
Use only mild, non-abrasive detergents
applied with a clean sponge or soft cloth.
Rinse well.
Remove screw
5J
COOKTOP LIGHT/NIGHT LIGHT
1. To replace the cooktop light/night light,
first disconnect the power at the main
fuse or circuit breaker panel, or pull
the plug.
2. Remove the screw from the side of the
light compartment cover and lower the
cover until it stops.
3. Be sure the bulb is cool before removing.
Gently pull the bulb from the receptacle.
Replace the burned-out bulb with a
120 volt, 20 watt (max.) halogen bulb
(WB36X10213), available from your
nearest Sears Parts & Repair Center.
Call 1-800-4-MY=HOMEP High-intensity
20 watt bulbs, available in most
supermarkets and hardware stores,
may also be used for replacement.
4. Push the new bulb straight into the
receptacle all the way, then raise the
light cover and replace the screw.
Connect electrical power to the oven.
37