Master BC35 Manual De Instrucciones página 4

en
►►1. INFORMATION REGARDING
SAFETY
IMPORTANT: READ AND UNDERSTAND
THIS OPERATIONAL MANUAL BEFORE
ASSEMBLING,
PERFORMING MAINTENANCE ON THIS
APPLIANCE. INCORRECT USE OF THE
APPLIANCE CAN
INJURY. KEEP
FURTHER REFERENCE.
IMPORTANT: This
suitable for use by persons (including
children) with reduced physical, sensory
and mental capacities or with lack
of experience or knowledge unless
supervised by a person responsible for
their safety. Children must be supervised
to make sure they do not play with the
appliance.
►1.1. Fill the appliance tank only with clean
water.
►1.2. Switch off and disconnect the
appliance from the mains before fi lling it.
►1.3. Do not move the appliance, once the
tank has been fi lled.
►1.4. When using the appliance, comply
with all local regulations and Standard in
force.
►1.5. Keep the appliance dry, in order
to avoid electric shocks. Hands must
always be dry.
►1.6. Use only in ventilated and dry areas.
►1.7. For indoor use only.
►1.8. Power the appliance only with voltage
and frequency as specifi ed on the data
plate.
►1.9. Only use extensions with three wires
appropriately connected to earth.
►1.10. Do not cover the appliance with
paper, cardboard, plastic, metal sheets
or any other infl ammable material during
use, in order to prevent any risk.
►1.11. The appliance must be used on a
stable and levelled surface, in order to
prevent any risk.
►1.12. When it is not used, disconnect the
appliance from the power plug.
►1.13. Do not block the air vent (rear
side) or the air outlet (front side) of the
appliance.
►1.14. The minimum safety distance
recommended between the appliance
and walls or other items is 0,5 m.
Figures and texts of this book are protected by COPYRIGHT.
COMMISSIONING
CAUSE SERIOUS
THIS MANUAL FOR
appliance is
►1.15. When the appliance is connected
to the mains or running, it must never be
moved, handled, topped-up or subject to
any maintenance operation.
►1.16. The
OR
included) must be kept at a suitable
safety distance from heat sources.
►1.17. In any case, the appliance must be
opened and/or repaired by authorised
after-sales centre.
►1.18. If the power cable is damaged, it
not
must be replaced by the technical after-
sales centre, in order to prevent any risk.
►►2. UNPACKING
►2.1. Remove all packaging materials used to
wrap and deliver the appliance and dispose
of them in compliance with the Standards in
force.
►2.2. Extract all items from the packaging.
►2.3. Verify if damage undergone during
transport. If the appliance appears damaged,
inform the dealer, where the purchase was
made, immediately.
►►3. ASSEMBLY
The device is equipped with wheels to facilitate
handling. Depending on the model, wheels can
be found already installed or not. Components
equipped with relative nuts and bolts are found
inside the packaging (Fig. 1).
►►4. OPERATION
WARNING:
"INFORMATION REGARDING SAFETY",
before switching the appliance on.
WARNING: Only use clean water to
prevent failures or other anomalies.
WARNING: Verify if your electronic system
is earthed correctly. Connection to the
mains must be made in compliance with
the National Standards in force. Power the
appliance only with voltage and frequency
as specifi ed on the data plate.
NOTE: These models can be connected to
the water mains, by connecting the pipe
to the fi tting
►4.1. SWITCHING ON:
►4.1.1. Open the tank door (Fig. 2).
►4.1.2. Fill the tank with water (Fig. 3); water
level must be within MIN and MAX level of
appliance (power
Thoroughly read
(Fig. 10).
½" (Max 3 bar)
cable
the