König KN-BM60 Manual De Uso página 5

Open up "Settings" on your iOS device and select "Wi-Fi" and let it search for a
8
network. The network will be "Wi-Fi-cam-p2p". Select "Wi-Fi-cam-p2p" to connect.
Now, open the "uCare Cam" app and select the tab at the bottom of the screen that
9
says "Wi-Fi Connect".
Select "Router mode", then "Next". Enter here the Wi-Fi network name (SSID) and
10
password of your home router.
After the IP baby and child monitor receives this information, it will restart. Please
11
wait for it to start up and connect to your Wi-Fi router. When it successfully connects,
the status LED colour will turn orange. It may take up to 5 minutes.
Then select the camera name in the "uCare Cam" app to connect.
12
Note: If the status LED colour does not turn orange, please check your Wi-Fi router
and make sure the IP baby and child monitor is within the signal area of your Wi-Fi
router. Then try this setup again.
Install your IP baby and child monitor by WPS connection mode
If your Wi-Fi router has a WPS (Wi-Fi Protected Setup) button, you can use it to set up the IP
baby and child monitor. (Must enable WPA/WPA2 encryption in Router). On the Wi-Fi router,
you will see a button labelled "WPS". It may also be called "QSS" or "AOSS"
Setup Wi-Fi - WPS mode
1
Open the "uCare Cam" app
bottom of the screen.
Select the tab:
Then select the tab:
Enter WPS mode
2
Power on your IP baby and child monitor. The status LED on the IP baby and child
monitor will be green for about 15 seconds.
Programme Loading
3
The status LED will flash red for about 15 seconds.
Press the WPS button on your IP baby and child monitor
4
Wait until the status LED flashes between red and green, then press and hold the
WPS/RESET button on your IP baby and child monitor for about 2 seconds to enter
WPS mode. The status LED will be flashing green.
Enter WPS mode on the Wi-Fi router
5
Press the WPS button on the Wi-Fi router
and select "Wi-Fi Setting" or "Wi-Fi Connect" at the
to enter Step 2 (see Figure 8).
5
ENGLISH