Service And Maintenance - Ferm GGM1003 Traducción Del Manual Original

EN
Charging the machine (with the charger
adaptor)
• P lug the small cable plug into the machine's
charging socket.
• P lug the charger into an electrical outlet and
wait for a while. The LED indicator on he
machine will lighten up and show the charging
status.
Operation
• Press the button on the base of machine 2
seconds to switch on
• Insert a glue cartridge into the gun, two when
using it for the first time.
• Wait 15 seconds for the glue to heat.
• Squeeze the trigger to release the glue.
• Replace the glue cartridge as soon as you
notice little if any glue is released from the
gun.
• Press the button again to switch off the tool.
• The machine will switch off automatically after
not being used for 4 to 5 minutes.

4. Service and maintenance

This machine has been designed to operate over
a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends upon proper machine care and regular
cleaning.
Always switch off the tool before
cleaning and maintenance work. Never
use inflammable liquids to clean the tool.
Use a brush to clean the glue gun.
• Keep the nozzle clean. Check before every
use there is no glue left on the nozzle.
• Remove any glue left inside the nozzle with
a pin.
Malfunction
Should the machine fail to function correctly, a
number of possible causes and the appropriate
solutions are given below:
1. The tool does not work when switched on
• The glue cartridge is empty.
• Replace the glue cartridge.
• Defective switch.
• Please contact the service address on the
warranty card.
4
Repairs and servicing should only be
carried out by a qualified technician or
service firm.
Lubrication
The device does not need any additional
lubrication.
Defects
If a defect appears due to a part wearing out,
please contact the service center on the warranty
card.
Environment
To prevent damage during transport, the appliance
is delivered in a solid packaging which consists
largely of reusable material. Therefore please
make use of options for recycling the packaging.
Damaged and/or disposed of electrical
or electronic devices must be dropped
off at recycling stations intended for that
purpose.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and
its implementation into national right, power tools
that are no longer usable must be collected
separately and disposed of in an environmentally
friendly way.
Warranty
Read the warranty conditions on the separately
supplied warranty card.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.