Zipper Maschinen ZI-BM870ECO Instrucciones De Servicio página 22

 Danger by the working area:
Take care of stones and other objects in the area to be mowed.
Danger of catching of ropes, wires, or loose trousers legs by the mower blade
 Danger for the hands (fingers):
Never touch the mowing blades during the operation. Severe cutting injury!
 Adverse health effects through vibration
A long, continuous use, or a regular use of the scythe mower by one person may influence
your health: blood circulatory disturbances (especially of your hands), joint damages are
possible. Therefore:Make breaks regularily and wear well cushioned gloves to reduce
vibration intensity.
 After operation the machine has to get cold. Otherwise, there's a high burning hazard!
 Electrocution when touching the spark plug socket when engine is running.
You can reduce remaining risks by following all security, operation and maintenance instructions.
13 ASSEMBLY
Unpack the ZIPPER scythe mower ZI-BM870ECO and check the machine and its parts for any
transport damage and for completeness of delivery.
• Install the height regulator (Fig.C1)
Mount the height regulator1 on the cutting bar2 as illustrated. Use the bolt M8x30,washer M8 and
locknut M8 fixing it.
• Mount the blade holder (Fig.C2)
Lightly grease the mounting bush1 and insert the blade holder2. Place the V belt3 around the
pulley4.
• Fix the blade holder (Fig.C3)
Hook the recoil spring1 as illustrated. Step4.Mount the cutting bar on the blade holder (Fig.C4) Place
the rocker block1 on the switch block2. Insert the rocker bolt3 into the rocker block. Use the bolt
M8x20, washer M8 and lucknut M8 fixing it.
• Install the shield cover. (Fig.C5)
Place the shield cover1 on the blade holder. Use the flange bolt M8x20, washer M8, washer M12 and
locknut M12 fixing it as illustra-tred.
• Install the handlebar (Fig.C6)
Insert the absorber block1 between the handle bar2 and Ex-arm-fixer3. Use bolt M8x70, rubber
washer, washer M8 and locknut M8 fixing it.
• Install the throttle lever, cutting clutch and forward clutch as illustrated (Fig.C7)
Note: The shake of this machine is very big on its work, so every bolt or
nut must be tighten especially well.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BM870ECO
ATTENTION
ASSEMBLY
22