Technical Data; Initial Use - nor-tec 70072 Manual De Instrucciones

RECHARGEABLE LED WORK LIGHT
Notes on safety.

Technical Data

Battery:
Protection class:
Lumen:
Light temperature:
LED type:
LED service life:
Angle of light:
Operating temperature:
Materials: Aluminium cabinet with tempered
glass
Dimensions:
Weight:
Mains charger:
Class II
Adapter
Charger connector
Indicator light
On/off button
10
7.4 V 1.8 Ah Li-PO
IP65
700
3,000 K
9 × Sanan 2835 SMD
25,000 hours
120°
-20 to +45°C
135×130×110 mm
950 g
220-240 V – 50/60 Hz

Initial use

1. Open the package, remove the work
lamp and accessories, and check the
mains charger and the glass, if these
parts are supplied. Contact your dealer,
if there parts are missing, or if the glass is
broken.
2. Use the mains charger to charge the
battery for three hours. The battery
is protected from overcharging. After
charging, you can turn on the work lamp
using the waterproof on/off button. The
work lamp can be illuminated for 1½–2
hours on a single charge.
3. Loosen the nuts, and set the work lamp's
cabinet to the desired angle. It can be
angled 360° left/right and 45° up/down.
4. Charge the work lamp immediately when
the red control light comes on.
Caution
• Important: Do not touch the work lamp
during or immediately after use, as there
is a risk you could be burned. Allow the
work lamp to cool down � rst.
• Must not be covered with paper or fabric.
• Keep away from any combustible
materials.
• The work lamp must not be used in
water, as it is IP65 approved.
• The light source in the work lamp cannot
be replaced. When the light source has
worn out, the whole work lamp must be
replaced.
• Do not use the work lamp in places
where the ambient temperature
exceeds 45°C. Recommended ambient
temperature is approximately -20 to
+45°C.