STATUS BUTTON
Turns on the Battery Status LED, to provide a quick three-state level of charge.
NOTE: When the monitor is first connected to a battery or charger, the Yellow/
Orange status LED will flash for 5 minutes. During this time, the monitor is in
access mode and its wireless network may be programmed or updated.
CONNECTED (BLUE) LED
Flashes when monitor attempts to connect to a wireless network. When a network
connection is made, the LED turns solid.
BATTERY STATUS LED
The LED will light for 8 seconds after the button is pressed.
When not charging:
Red – 50% or less charged (≤12V)
Yellow/orange – 51-74% charged (12.0-12.4V)
Green – 75% or more charged (≥12.4V)
When charging:
Red – 23% or less charged (≤12V)
Yellow/orange – 24-99% charged (12.0-14.3V)
Green – 100% charged (≥14.3V)
4. INSTALLING THE APP AND REGISTERING YOUR MONITOR
• Before you begin, have your monitor ID card on hand.
• Download and install the SchuLink+
NOTE: For Apple devices, requires iOS 9.0 or later; Android devices, OS 5.0 or later.
Google Play and Android™ are trademarks of Google Inc.
Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries.
App Store is a service mark of Apple Inc., registered in the U.S. and other countries.
SETTING UP THE MONITOR'S CONNECTION TO A WIRELESS NETWORK
NOTE: Monitor operation requires an internet connection. Depending on your
wireless router's location, you may need a wireless extender, to bring the signal
close enough to the vehicle for proper operation.
1. Open the App on your mobile device.
2. Press the
3. Tap the three short horizontal bars
4. Choose SETUP.
5. Swipe screens and follow directions for setup to a wireless network.
Home icon.
App (Apple store or Google Play).
to bring up a menu.
• 3 •