Disinfecting
Please follow the following steps to disinfect your nebulizer unless otherwise
specified by your physician. It is suggested that the unit is disinfected after the
last treatment of the day.
1. Use one part white vinegar with three parts distilled water. Make sure mixed
solution is enough to submerge the nebulizer, mouthpiece and mask.
2. Complete Rinsing Steps 1-3.
3. Wash nebulizer, mouthpiece and mask in warm water and a mild detergent.
Then wash them in hot tap water.
4. Submerge these parts in the vinegar and water solution for thirty minutes.
5. Complete Rinsing Steps 3-5.
Cleaning the Compressor
1. Wipe daily with a damp cloth.
2. Do not use any powdered cleaners or soap pads, which may damage the
finish.
Filter change
CATUION:
Do not operate the compressor without a filter. Only use filters supplied by your
distributor. Do not wash or clean the filter.
1. Changing procedure:
A. Remove the filter cover
B. Replace the used filter with a new filter.
C. Replace the filter cover.
6. REPLACEMENT PARTS AND ACCESSORIES
Contact your healthcare distributor for replacement parts or accessories.
6