Using For The First Time; Care And Maintenance - KAIZENTECH AE-80 Instrucciones De Uso

Using for the first time

Always hold the machine with both hands.
Press the starting lockout button (1). Press the ON/OFF switch (2).
The integrated electronic controls will start up the machine in a controlled fashion. The more pressure
you apply to the ON/OFF switch, the faster the machine will run.
the ON/OFF button is not possible.
To stop working, release the ON/OFF switch.
Machines with 2-speed gear units have two maximum speeds available (First gear: Slow / Second
gear: Fast). T o change from one gear to the other, turn the gear selector through 180°.
Always reduce the speed when submerging the mixing tool in the mixing material or lifting it out.
Once the mixing tool is fully submerged, increase the speed again to ensure that the motor is
adequately cooled.
During mixing you should guide the machine around the mixing container. Continue mixing until all
of the mixing material is completed mixed.
After ending place the machine on the guard handle.
Clean the mixing tool after you have finished your mixing work.

Care and maintenance

Before you carry out any operations on the machine, including changing the mixing tool, always pull out the
mains plug first.
Keep the machine and mixing tool clean. Keep the HEXAFIX coupling and the end of the mixing tool shaft clean and
freely moving at all times. Grease the hexagon guide of the coupling at regular intervals with suitable grease.
Keep the ventilation slits (5) clean so that the machine can be properly cooled.
The machine is equipped with self-deactivating carbon brushes. This means that the machine will
shut itself down once a certain level of wear is reached. The carbon brushes can be replaced by an
authorized customer service center or by the Service center.
Have repairs carried out only by an approved workshop or by your Service. Only use original
KAIZENTECH replacement parts.
Warranty
The manufacturer provides a warranty within the framework of his terms and conditions of delivery in accordance with the
requirements of statutory/country-specific provisions.
Should you need to make a claim under the warranty, please provide us with your invoice or delivery note.
On no account will any warranty claims be accepted if any repairs are carried out by third parties. In the event of any
irregularities, please send the machine to us.
We shall not accept any claims under the warranty for damage resulting from natural wear, overloading, improper handling
or inadequate maintenance.
Complaints can only be accepted if the device is sent to the KAIZENTECH Service center undismantled.
Disposal
The machine, accessories and packaging should be properly recycled and never disposed of with household waste.
All devices which are no longer suitable for use can be taken for recycling to the nearest depot for electrical scrap or
returned to the manufacturer delivery free.
CX-HF_17sprachig_0208.indd 7
Due to savety reasons, locking of
ON/OFF switch
Gear selector
29.05.2008 15:12:53