Maintenance And Troubleshooting; Cleaning The Touch Screen; Change Wi-Fi Network Or New Network Password; Troubleshooting - VULCANO Control Connect Manual De Instalación Y De Funcionamiento

7

Maintenance and troubleshooting

7.1

Cleaning the touch screen

15 sec
Fig. 17 Touch screen protection
▶ Clean the touch screen within 15 seconds with a clean, dry
cloth.
7.2 Change Wi-Fi network or new network
password
To log the controller onto a new Wi-Fi network or if the existing
network has a new password:
▶ Reset the controller ( section 7.3.2).
▶ Follow the step to set a Wi-Fi network ( section 4.6.3).
7.3

Troubleshooting

Fault messages from the boiler are visible on the
display and are sent automatically from the
controller to the app.

7.3.1 After a power cut

All settings are saved during a power cut. After the connection
is re-established with the Wi-Fi network, the settings will be
synchronised with the external server.
▶ Check the date and time setting
If a connection can not be made with a Wi-Fi network, the date
and time settings can be applied through a direct Wi-Fi
connection with the app from a smart device. Date and time are
automatically synchronised.
Control Connect – 6720818270 (2016/02)
00.00.00
6720815753-4.1TD

7.3.2 Reset controller

If the controller no longer works properly, it can be discon-
nected briefly from the wall plate and then re-attached
( fig. 7, page 28).
If this does not solve the problem, with the controller mounted
on the wall, the reset key ( fig. 18) can be pressed for a few
seconds to remove the fault. If the fault occurs again, then
contact your installer or the Bosch Group Technical Support
team.
Reset!
Using the reset key deletes all personal settings
and the Wi-Fi connection has to be set up again.
Fig. 18 Reset
Maintenance and troubleshooting
6 720 804 655-020.1N
31