Getting Started; Insert Batteries; Set The Clock Manually - Explore Scientific RDC1008 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please ensure the polarities (+/-) of the batteries match
upon installation.
3. Reattach the battery door.
NOTE: Replace batteries when the display is dim.
CLOCK
CLOCK RECEPTION
1. When you insert or replace the batteries, RCC reception is initiated. To manually start RCC rece-
ption, press and hold the [
2. If the RCC receiving process is successful, a completed RCC symbol [
display and the date and time will be set automatically. If it fails, press and hold the [
to re-initiate RCC receiving.
3. If the device is still not receiving the signal, please proceed to set the time manually.

SET THE CLOCK MANUALLY

1. Press and hold [
2. The setting parameter will flash.
3. Press [ ▲ ] button once, the figure will increase 1 unit. Press and hold the [ ▲/CF ] button, the
figures will increase rapidly.
4. Press [ ▼ ] button once, the figure will decrease 1 unit. Press and hold the [ ▼/RCC ] button, the
figures will decrease rapidly.
] button.
] button to enter into time and date setting.
] will be shown in the
] button
7
EN
IT
DE
FR
ES
NL