Electrical Connection; Dispenser Connection - ADC EcoWash EWH-25 Manual De Instalación

8.4.Electrical connection

WARNING: Risk of electrical shock
To access the connection strip, remove the switch cover and attach the hose cable to the rear panel. In large capacity
models (group D) the electrical connections are located in the rear cabinet, the circuit breaker must be set to "0" in
order to open the door
Connect the terminal strip and check that the connections correspond to the operating voltage.
Place an autonomous power switch (I) at the current input, with a minimum of 3 mm between contacts. Fit a 300mA,
type A, immediate response differential protection.
INSTRUCTIONS FOR CONNECTING THE EARTH
This appliance must be connected to an earthed metal, permanent wiring system, or an earth conductor should be
installed with the circuit conductors and connected to the earth discharge terminal or the appliance cable.
Connect the terminal strip and check that the connections correspond to the operating voltage.
Fit a 300mA, type A, immediate response differential protection.
The machine must be connected to earth.
If the voltage frequency is 60 Hz, change the drainage valve connection.

8.5. Dispenser connection

1: 230 V electrical signal. For dispenser 1 (prewash)
2: 230 V electrical signal. For dispenser 2 (wash)
3: 230 V electrical signal. For dispenser 3 (bleach)
4: 230 V electrical signal. For dispenser 4 (softener)
5: 230 V electrical signal. For dispenser 5 (ONLY PROGRAMMABLE MODELS)
6: 230 V electrical signal. For dispenser 6 (ONLY PROGRAMMABLE MODELS)
7: 230 V electrical signal. For dispenser 7 (ONLY PROGRAMMABLE MODELS)
7
ENGLISH