Safety Tips; Connecting To Mains Supply; Wine Cabinet Installation - COOL HEAD CW 500 Manual De Instrucciones

Safety Tips

9. WARNING: Keep ventilation openings, in the appliance
enclosure or in the built-in structure, clear of obstruction.
10. WARNING: Do not use mechanical devices or other means to
accelerate the defrosting process, other than those
recommended by the manufacturer.
11. WARNING: Do not damage the refrigerant circuit.
12. WARNING: Do not use electrical appliances inside the food
storage compartments of the appliance, unless they are of the
type recommended by the manufacturer.
Power Supply Connection
1. Nominal voltage/Frequncy:220~240V~/50Hz;
2. Standard socket with earth connection(12~16A,250V~)
3. If the power cord is damaged, or the plug does not match the socket, and the socket is not equipped with an earth
connection, etc, you must have it checked or replaced by a qualified electrician to prevent any risks.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons
in order to avoid a hazard.

Wine cabinet Installation

1. When you receive the cabinet, make sure when you unpack it there is no flaws in its external appearance (from
shocks, deformation, etc.)
2. Open the door and check all interior fittings and supplied items if are all complete (shelves, instruction, control panel,
etc.) Please install it according to the following points if the shelves or shelf brackets fall off during transit.
3. Carry your wine cabinet to the final place to see if there is no problem with it after checking. Observe the following
when placed:
A Ensure that there is a minimum of 5cm between your wine cabinet and the left & right wall; leaving a space of at
least 8cm between the back cabinet and the wall.
B Position the wine cabinet on a flat level surface, if not, adjust the feet of wine cabinet to keep level.
* Away from sources of heat and high humidity areas (laundry room and bathroom, etc).
* Do not tilt it at an angle of more than 45° when move the cabinet. Allow a minimum 10-minute interval between
transit and re-starting.
* Make sure the ventilation is free if you wish to install your cabinet into a worktable, otherwise ,it will reduce the
effect of usage.
4
GB