EDM 08759 Manual De Instrucciones página 27

Lawn mower
Operation
Cutting height adjustment
The mower has 5 different heights. The cutting height
ranges from 25 mm to 75 mm.
Start
Never start the mower directly on long grass.
1. Open the battery cover on the motor unit, slide in the
battery and click it in place.
2. Make sure the safety key (12) is inserted.
3. Hold the start button down and activate the handle bar
for engine brake to start the motor. Release start button
once started.
Note: As long as operating the mower, the handle bar for
engine brake must be engaged.
Stop
Release the engine brake to turn off the mower and the
engine.
Note: The blades will still rotate at up to 3 seconds after
stopping.
Remove the battery
To remove the battery, press and hold the latch button
under the battery and pull it out.
Working time
The working time per full charge depends of several factors,
like length of grass, cutting height and cutting methods
(mulching or collection).
Variable motor-speed
The motor adjusts the blade-rotations to match the load
(length and thickness of the grass). You will therefore hear
that the motor-speed will go up/down while cutting the
grass. This is perfectly normal and ensures a more
energy-effective use of the power from the battery.
Indicator for full grass collector
The practical indicator (A) on the grass collectors tells, when
it is full of grass and need to be emptied.
EN INSTRUCTION MANUAL
Blade
Inspection of the blade:
• Tilt the mower with the front upwards.
• Inspect blade for damage, cracks or excessive rust or
corrosion.
• Check that the blade bolt is tightened.
Note: A dull blade can be sharpened! But a blade that is
worn, bent, cracked or otherwise damaged must be
replaced.
Removing the blade
If you remove the blade to sharpen or replace it, you must
use a torque wrench and some heavy gloves to protect your
hands.
1. Loosen the blade bolt with the included tool. Use a piece
of wood to prevent the blade from turning around.
2. Remove the bolt, washer, blade and blade holder in that
order
3. Sharpen or replace the blade.
4. Insert the blade holder, blade, washer and bolt in that
order.
5. Tighten the blade bolt with 25 Nm with the included tool.
Use a piece of wood to prevent the blade from turning
around.
Warning: A blade must be sharpened so it is in 100 %
balance, otherwise it may cause vibrations that could
damage the engine. Damage to engine due to faulty
sharpening is not covered by warranty. We therefore
recommend letting a service center sharpen the blade.
REF. 08759