Operation Instructions; Service - BOXER DB42S Manual De Operación

underneath the gun cleaner. Make sure to have the ventilation
running during this procedure.
Place the second drum, now half full, on the fl oor on the
right-hand side of the fi rst drum (item 3 illustration 2). Insert
the second group of hoses containing the 6mm hose into this
drum (item 5 illustration 2). Make sure that the hose is properly
led into the drum all the way down to the bottom, and that the
opening is well sealed by the tapered plug.
The solvent system is now fi lled-up on the left side of the unit.
Both drums should be half full. The left-hand drum, contains
the solvent that will be recirculating for the automatic wash cy-
cle, and the right-hand drum contains clean solvent for rinsing.
The contents of the right drum will gradually be used up and
transferred to the left drum.
Now the solvent fi ll-up procedure
repeat
the unit.
Operating instructions
Operating instructions should be formulated on the basis of
this manual and translated into the language spoken by the
employees. It should always be available close to the machine.
To avoid confusion, the employees must be informed about the
solvent currently being used in the machine.
OPERATING INSTRUCTIONS
The following procedure is valid for either side of the unit:
Empty the spray-gun of any residual paint into a separate spills-
dish.
Open the main valve for compressed air (item 7 illustration 1).
Open the lid for the automatic washer (make sure it `clicks` into
the full open position).
Place the spray-gun inside (see illustration 5).
Be sure to fi t the trigger clip following illustration 6, and to
push the spray-gun up against the nozzle for the paint-channel
(item 1 illustration 5) before you lock it into position with aid of
the magnets of the trigger clip.
If you prior to cleaning prefer to remove the Air-cap and the
needle of the spray-gun, then place those items as shown by
arrow 5 in illustration 5.
Close the lid, and start the automatic pre-wash cycle by press-
ing the foot pedal No.8 in illustration 1. The spray-gun will now
be automatically cleaned for approx. 1.5 minutes with circulat-
ing solvent.
16019 rev 2014-11-06
When the the automatic pre-wash cycle is completed, the lid
can be opened and the spray-gun taken out. It can now be
manually further washed or rinsed if required.
By pressing foot pedal No.10 in illustration 1 (NOTE: press it all
the way down !), recirculating solvent will be fed through the
brush placed in the sink (item 1 illustration 7).
By pressing foot pedal No.11 in illustration 1, clean solvent
will be fed through the spray-nozzle placed in the sink (item 2
illustration 7).
The brush and spray-nozzle in the sink can be used indepen-
dently of the automatic washer at any time, provided that the
lid for the automatic washer is closed. The intensity of the spray
can be adjusted with the air-fl ow restrictor (item 1 illustration
14).
Connect the spray-gun to the air-line on the left side of the
of machine (item 4 illustration 1), and blow out the spray-gun
for the right side
through the funnel in the sink (item 3 illustration 7). By using
this funnel, you prevent the fumes from spreading within the
premises.
Finally, the spray-gun can be blown dry by using the air-gun on
the right side of the unit (item 12 illustration 1).
Close the lid after cleaning.

SERVICE

Weekly:
– Remove the strainers at the bottom of each automatic
Monthly:
– Remove the fi ve nozzles in each automatic washer and
When changing drums:
– Check and if necessary clean the strainer on the suction
washer (item 2 illustration 5) and clean them,
get to re-fi t !
clean them with clean solvent. (see illustration 8).
hose for circulating solvent.
do not for-
5