Tabla de contenido
Publicidad
Troubleshooting
1. I inserted the Utility CD-ROM into my computer's CD-ROM Drive but the installation menu does not
appear automatically. What should I do?
1. For Windows 7, if the installation menu does not appear automatically, click on the Windows Icon on the
bottom left hand corner of the screen, click the "Search programs and files" box, and type D:\autorun.exe,
where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press the ENTER key
on your keyboard .
2. For Windows Vista, if the installation menu does not appear automatically, click Start, click the Start Search
box, and type D:\autorun.exe where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive,
and then press the ENTER key on your keyboard.
3. For Windows XP, if the window does not appear automatically, click Start, click Run and type
D:\autorun.exe where "D" in "D:\autorun.exe" is the letter assigned to your CD-ROM Drive, and then press
the ENTER key on your keyboard.
2. IP Setup is unable to detect my video encoder. What should I do?
1. Verify that you have followed all the steps in Section 2: Hardware Installation.
2. Disable any software firewall programs such as ZoneAlarm or Norton Internet Security. If you are using
Windows 7, Vista or XP disable the built in firewall.
3. Click on Search in IPSetup.
4. Reset the video encoder. Take a pin or paperclip and press the reset button on the side of the unit for 15
seconds.
3. I do not have a DHCP server or DHCP is disabled on my network and I am unable to configure the TV-
VS1/TV-VS1P. What should I do?
1. Go to the TCP/IP settings on your computer and assign a static IP address on your computer's network
adapter in the subnet of 192.168.10.x. Since the default IP address of the TV-VS1/TV-VS1P is
192.168.10.30, do not assign a static IP address of 192.168.10.30 on your computer's network adapter.
2. Open Internet Explorer and enter http://192.168.10.30 into the address bar.
4.
When I click on Live View the image does not load?
1. Make sure that you are using a browser that supports ActiveX or Java.
2. Make sure that ActiveX or Java is installed. See steps 10 to 12 in Section 2: Hardware Installation for
ActiveX installation. Go to
5. I forgot my password. What should I do?
Take a pin or paperclip and press the reset button on the side of the unit for 15 seconds. This will return
settings back to factory defaults. Open up the IP Setup program to find out the IP address of the camera (see
step 8 in Section 3: Configure the TV-VS1/TV-VS1P.) If you do not have a DHCP server on your network, the
default IP address is 192.168.10.30. The default administrator ID and password is admin.
6. Please give me an explanation of all the LEDs and Buttons.
LED/Button
Power LED
Network Port Link/
Act LEDs
Reset Button
If you still encounter problems or have any questions regarding the TV-VS1/TV-VS1P, please contact TRENDnet's
Technical Support Department.
www.java.com
to download and install the Java plug-in.
Color
Sequence
Amber
Solid
N/A
Off
Solid
Green
Blinking
N/A
Off
N/A
N/A
Definition
Device is on
Device is off
LAN port connected at 10/20 Mbps or
100/200Mbps (Half/Full Duplex)
LAN port data transmitting/receiving
10/20Mbps or 100/200Mbps (Half/Full Duplex)
LAN port is disconnected/No Ethernet Link
Hold 15 seconds to reset device to factory defaults.
8
Publicidad
Tabla de contenido
