Possible Problems; Cleaning And Storage - JOCCA 2105 Manual De Instrucciones

26-E
grammed for 30 minutes and massage intensity (c) for level 5.
-For automatic start an armchair is programmed a massage from
mode 1 till mode 10, an automatic light mode AUTO switches on
and each of massage mode will last 1 minute.
-If you want to add massage intensity, press
indicate you an intensity level from1 to 10.
-If you press , a massage automatic mode fixes.
-If you press , you can programme massage time from 1 to
99 minutes. For automatic start an armchair is programmed for 30
minutes, press to achieve the wished time.
-If you want to change a vibration type, you must press
to select a vibration mode from level 1 to 10, a light will indi-
cate you a massage mode.
-If you want to select a massage zone: calves, gluteus, lower
back, higher back or all together, press
-If you want to active a heating function, press
indicate you an activated function.

POSSIBLE PROBLEMS

-Check the following possible functioning problems if the massa-
ge armchair does not work properly. These problems can be sol-
ved in an easy manner following the instructions below.
-Do not dismantle or repair any part of the armchair by yourself.
-If vibration does not work:
Possible problems
An adaptor is not plugged in
correctly.
A remote control is discon-
nected.
and a light will
or
.
, a light will
Possible solutions
Plug in correctly an adaptor.
Connect a remote control to an
armchair and press I/O button.
-If vibration has been stopped suddenly or works in an oppo-
site direction than was marked:
Possible problems
Vibration stops automatically
because a timer is predetermi-
ned for 30 minutes.
Does not work correctly.
A connector is not connected
correctly.

CLEANING AND STORAGE

When the armchair is not used:
-Unplug the device if it is not going to be used for a long time.
-Put the armchair in a clean and dry place.
Conservation:
-Always maintain the armchair clean and free from dust.
-Maintain the armchair in a place where it is not affected by humi-
dity.
-When the armchair is not used for a long period of time, use a
cloth to cover it and protect it fro dust.
-Do not place the armchair in places with direct exposition to sun-
light or high temperatures; the leather could be discolored.
Maintenance of the massage armchair:
-Block the power supply and unplug the device before cleaning
the armchair.
Maintenance of the main body of the massage armchair:
-You can use a neutral detergent to clean the plastic parts and the
E-27
Possible solutions.
Switch on a remote control
pressing On/Off.
Disconnect a device from light
during 20 minutes and after-
wards connect it again.
Check if all the connections
have been made correctly.