Publicidad
Idiomas disponibles
Idiomas disponibles
INSIDE Corners 90
Cut moulding upside down. Set saw to 45
degrees. Adjust angle if wall is not square.
There are four basic cuts you will make with Crown-Cut: INISIDE CORNERS (90 degree), OUTSIDE CORNERS (90 degree),
LEFT OVER RIGHT SPLICE JOINTS, and RIGHT OVER LEFT SPLICE JOINTS. Splice joints don't always fit perfectly because
of differences in your moulding's profile. Staging the overlap of the splice joint to fit your room will help hide the differences. A
good rule of thumb to follow is this: if you entered the room and could see the splice joint to your right, use the right over left
splice joint. If you entered the room and could see the splice joint to your left, use the left over right splice joint. If your walls are
out of square, adjust the angle accordingly. Be sure to test fit using scrap pieces of moulding. Before cutting, read the SAFETY
RULES below.
Left over Right Splice Joint
make an
"outside left"
cut on this piece
Cut moulding upside down.
Set saw to 45 degrees.
Right over Left Splice Joint
make an
"inside left"
cut on this piece
Cut moulding upside down.
Set saw to 45 degrees.
©Copyright Bench Dog, Inc. 2005
Read These Safety Rules Before Cutting!
1. Keep hands at least 4" from saw blade at all times!
make an
2. Always cut the moulding upside down.
"inside right"
cut on this piece
3. Always position Crown-Cut on the miter saw so the tool
4. Hold tool and moulding securely against miter saw fence.
5. Allow the blade to come to a complete stop before lifting
6. Provide adequate support for long pieces of moulding.
7. Don't cut or recut pieces shorter than 7".
8. Never cut cross-handed.
9. Always wear safety glasses and ear protection.
10. Don't wear loose fitting apparel.
11. Be sure saw blade is sharp and properly installed.
12. Avoid cutting nails and knots.
13. Read and follow your saw's owner's manual
make an
"outside right"
14. Don't remove cut-off pieces before the
cut on this piece
15. Childproof your workshop with locks
16. Disconnect power before servicing
17. Always keep the blade guard in
18. Only use cross cut finishing
OUTSIDE Corners 90
Cut moulding upside down. Set saw to 45
degrees. Adjust angle if wall is not square.
clears the blade path by at least 1/2".
the blade and removing the moulding.
and safety warnings before using this tool.
blade has stopped.
and master switches.
or changing blade.
its factory condition.
type miter saw blades.
Publicidad
