Grounding Instructions; Heater Installation - Dimplex EMC4240 El Manual Del Propietario

IMPORTANT INSTRUCTIONS

grounding Instructions

This heater is for use on 240
Volts. The cord has a plug as
shown on Figure 1. no adapter
should be used with this unit.
The type of outlet is a 240 Volt
grounding outlet. When properly
installed, it provides a ground
connection through the cord to
the heater to protect the operator
from electric shock.

Heater Installation

Heater Location And
Clearances
The heater is intended for hori-
zontal use on a hard floor, table
top, desk or on shelf, and the like.
The discharge air should wipe the
walls without blowing directly on
them (Figure 2).
Ensure the air discharge is paral-
lel to or away from walls.
! NOTE: To prevent personal
injury always use a licensed
electrician to install new outlets or
circuits.
CAUTION: When turning and/
or tilting the heater do not block
the exhaust opening.
6
Figure 1:
Plug and outlet
configuration for 240
Volt, 30 amp circuit
Plug
Figure 2
outside Wall
Use Of Support Stand
(EMC4240 only)
The pre-installed support stand
can be swivelled out to allow an
upward angle for the air dis-
charge. When in down position,
the heater should be placed on
a flat surface such that it will be
stable and not fall over (Figure 3).
ground
outlet
www.dimplex.com