Aleratec HDD PortaCruiser 350108 Guia De Inicio Rapido página 10

Using the HDD PortaCruiser
Duplicator Mode
Main Menu: Copy HDD
The "Copy HDD" function performs an actual copy from the source HDD to
the target HDD. The target HDD must be at least as large as the source. The
HDD PortaCruiser will copy every block of capacity on the source HDD.
1. Load the source HDD and the target HDD into the HDD PortaCruiser.
The system will auto-detect the hard drives. After the drives have been
detected, a screen similar to the one below will be displayed.
1. Copy HDD
Note: Before copying be sure that the capacity of the target HDD is equal to
or larger than the source hard drive.
ENT to start copying. The system will auto-detect the hard drives.
2. Press
The following information will be displayed.
Detect Drives
Please wait...
3. During the copy process the HDD PortaCruiser will display progress
information.
Copy - 36MB/s
235.7GB
The amount of data remaining to be transferred (shown in gigabytes),
and time will be displayed in decreasing increments as the percentage of
completion increases.
Note: The copying speed, capacity and duration may vary from one source
hard drive to another.
8
149.1GB


0%
1:48

www.aleratec.com
ENT RESET
ESC MUTE
ENT RESET
ESC MUTE
ENT RESET
ESC MUTE