Using Your Appliance - Krups EXPERT 9000 Serie Manual De Instrucciones

• Do not use your appliance if it is not
working correctly or if it has been damaged.
If this is the case, contact a KRUPS approved
service centre (see list in service booklet).
• Any work on the appliance other than
normal care and cleaning by the customer
must be carried out by a KRUPS approved
service centre.
• Do not immerse the appliance, the power
cord or the plug in water or in any other
liquid.
• Do not allow the power cord to hang within
the reach of children, to come close to or
into contact with the hot parts of your
appliance, any other source of heat or any
sharp edge.
• If the power cord or the plug is damaged,
do not use the appliance. To avoid any risk,
these must be replaced by an approved
KRUPS service centre (see list in the service
booklet).
• Do not put any accessories containing metal
in a microwave oven.
• For your safety, only use KRUPS accessories
and spare parts that correspond to your
appliance.
• Always remove the blender (d) before
activating the release button (a3) for the
multifunction head (a4).
• Always use the pusher (e7) to feed food
items down the feed tube of the mincer (e);
never use fingers or cutlery or any other
implement. Do not touch moving parts.
• Handle the blades of accessories (d, e, f, g)
with great care; they are extremely sharp.
• Do not touch the whisk, mixer blade or
kneading hook while the appliance is in
operation.
• Do not use the spatula while the
appliance is in operation.
• Only remove the accessories when the
appliance has come to a complete stop.
• Do not let long hair, scarves, ties, etc. hang
over the appliance when in operation.
• Never insert utensils (spoon, spatula
etc.) through the feed tube of the cover
(b2) or (d4).
• Do not operate the blender without its
cover.
• Only use one accessory at a time.
• The appliance must not be used in proximity
to a microwave appliance or mobile phone.

Using your appliance

1 - ADJUSTING THE HEIGHT OF YOUR
ACCESSORIES
Your accessories are equipped with a system
for adjusting the height above the bottom of
the bowl for optimum results.
• Unplug the appliance.
• Press the release button (a3), lift the
multifunction head and insert the whisk,
mixing blade or kneading hook.
• Hold it in position and loosen the nut (using
a flat spanner).
• Lower the head of the appliance (a4) with
the button (a3) pressed until a click is heard.
• Adjust the height by turning the shaft.
Adjust the accessories to the ideal position,
i.e. as close as possible to the sides of the
bowl without touching it.
• Lift the head (a4) of the appliance again,
holding the whisk, mixing blade or kneading
hook in position, and retighten the nut.
• Before using for the first time, clean all parts
of the accessories with soapy water. Rinse
and dry.
• Place the appliance on a flat, clean and dry
surface and then plug in your appliance.
• It can be started in a number of ways:
. Intermittent (pulse) operation: turn the
speed control knob (a1) to the pulse
position (a2) repeatedly for better control
of the preparation process.
. Continuous operation: turn the speed
control knob (a1) to the desired setting
from 1 to 12 according to the preparation
task to be performed.
You can change the setting during
preparation.
. Stop: return the knob (a1) to the 0 setting.
Important: the appliance will not start if
the cover (a6) is not latched shut.
17