Getting Started; Basic Operation - Polycom SpectraLink 8002 Guía De Referencia Rápida

GETTING STARTED

Your SpectraLink 8002 Wireless Telephone uses radio wave technology to
send and receive voice and data transmissions. It is designed to operate
much like a cell phone. However, the handset uses the private
communication system installed in your facility and will not operate
outside the area covered by this system.
The handset's Battery Pack must be fully charged before
its first use. Place the handset into the Charger for a
minimum of two hours before using it for the first time.

Basic Operation

If you want to Then
Turn the handset on
Turn the handset off
Unlock the keypad
Lock the keypad
Place a call
4
Press and hold the
sound.
Press and hold the
sound. If you are in a call, hang up first, then
turn off the handset.
Press the softkey, then
Unlk
While in standby mode press
.
Select
Press the key and wait for a dial tone.
START
Dial the numbers and listen for the ring to
indicate the alerting of the called party.
Note: Line 1 is the default line
START
key until two chirps
key. One chirp will
END
.
#
, then
FCN
English