Cleaning And Maintenance - Klarstein Dr. Watson Heatzone Manual De Instrucciones

Switch positions
0 The heat pad is switched off, the operating control display is off.
1 Lowest heat level, the operating control display shows "1".
Level 1 is recommended for continuous operation.
2 Middle heat level, the operating control display shows "2".
3 Highest heat level, the operating control display shows "3".
Automatic cutout
• The heat pad is equipped with an automatic cutout. This switches the unit off after
90 minutes of operation, independent of the heat level selected. Return the switch to
position "0".
• However, to switch the heat pad back on, move the switch back to position "0" and
then move it to the heat level required.

CLEANING AND MAINTENANCE

• Before cleaning the pad, unplug it from the mains outlet and let it cool down for at
least ten minutes.
• The heating pad is equipped with a detachable cable. Disconnect the plug and
remove the cable from the heating pad.
• You may wash the heating pad gently by hand. The best way to do this is to put
the heating pad in a bath with lukewarm water and some mild detergent and then
gently squeeze it out.
• Rinse the heating pad several times to remove all the detergent.
• To dry, stretch the pad out on a flat surface.
• Store the unit in a clean and dry place, laid out flat with nothing covering or resting
on top of it.
• Only use the appliance once it is completely dry.
EN
13