Installation - Connections - Uniteck UNIPOWER 150.12Q Manual De Instrucciones

EN

INSTALLATION - CONNECTIONS

Before any connection, check that the inverter is OFF.
 Unipower 150.12Q/150.24Q only: connect your inverter to your battery with the cigarette lighter plug.
 Unipower 350.12Q/350.24Q only : connect your inverter directly on your battery with the tong cables
:
- connect the black cable to the negative born of the battery (-),
- connect the red tong to the positive born of the battery (+).
Caution : Firmly tighten the tongs/the terminals, otherwise there are risks of : non supply, abnormal
overheating of the cable, and damages of the supply of the inverter or fire.
 For all Unipower (except Unipower 150.12Q/150.24Q and 350.12Q/350.24Q), connect your inverter
directly on the battery by the eyelet cables with battery terminals (not provided)

- connect the black cable to the negative born of the battery (-)
- connect the red tong to the positive born of the battery (+).
Caution : Firmly tighten the tongs/the terminals, otherwise there are risks of : non supplier, abnormal
overheating of the cable, damages of the supply of the inverter or fire.
 Put the switch of the Unipower ON. The led lights on as soon as the device is on.
 Connect the device to supply with the Unipower or via the 230V plug or via the 5V USB port for the
Unipower 150.12Q/150.24Q and 350.12Q/350.24Q (cf. USB connexion part).
 After using the inverter :
- disconnect the device to supply
- put the switch on OFF
- then disconnect the tongs of the battery of the cigarette lighter connexion.
Caution : The metallic parts may be hot. Avoid to grasp it with the hands or to put it next to
inflammable products.
Use on a start up battery of a vehicle
Unipower can be used motor on or off.
!
Caution : While starting the motor, disconnect the Unipower from the cigarette lighter
Caution
plug.
Earthing
For safety reasons, do the earthing of you Unipower inverter.
30/68
. .
WWW UNITECK FR