Keypad Functions - MEI CASHFLOW 7000 Serie Manual De Instrucciones

On the front of the CashFlow
has three LED's, six function buttons, and depending on the CF7000 model a
large LCD display.
This keypad allows you to dispense coins from the five-tube dispenser, access &
navigate through the configuration menus and monitor the status of the CF7000.
CF7400
1
1 3 LED's
2 A to E
3 Display (LCD)
4 'Mode' Button
5 Service Connector
The LED's provide a visual indication by light flashes that report the state of the
CF7000. An LED can either be ON, OFF or FLASHING. These light flash codes
can indicate when the CF7000 is operating normally, is in configuration/program
mode or has a fault.
The blue keys (marked A to E) have two functions.
When the CF7000 is in idle mode, pressing a blue button on its own will dispense
a coin from that tube. When you press and hold the blue button for approx. 4
seconds, this activates auto dispense (latch dispensing of coins) until the tube is
empty of coins. If however, the yellow (mode) button is pressed, the blue buttons
are then used for navigation through the CF7000 service mode and setup mode
menus.
(Setup menus are only available on CF7900)
Service Mode: gives access to the most frequently used product configuration
options.
(See Service Mode Options - Page 6)
Setup Mode: gives access to general product configuration options that are
required when setting up your CF7000.
www.vendival.com

KEYPAD FUNCTIONS

®
7000 there is a user interface keypad. The keypad
2
4
5
Red, Amber, Green
Dispense coins & navigate through menus
Menu information & warning display
Access service & setup menus
CPM Compatible
(Refer to the LED light code section for more information)
1
(See Setup Mode Menus - Page 7)
Page 4 of 10
Tel. 902 07 07 59 - Whatsapp 615 35 50 96
CF7900
2
3 4
5