TDK-Lambda CPFE500F Manual De Instrucciones página 14

CPFE500F Handbook
Input Parameters
Parameter
Nominal input voltage
Input frequency range
Maximum input current
Output Parameters
Voltage Adjustment Range
designation
12 9.6 - 14.4V
24 22.4 - 33.6V
28 22.4 - 33.6V
48 38.4 - 57.6V
SELV Outputs
The CPFE500F-12 and CPFE500F-24 are classed as having SELV outputs. The CPFE500F-48 is classed as having
a Non-SELV output.
Input Connections:
Mains input connection by 3way AMP 'Mate-n-lock' connector
Mating 3-way housing: AMP 350766-1.
Mating crimp terminals: AMP 926893-1 (14~20AWG), 926895-1 (18~24AWG)
Pin 3 : Live, Pin 2 : Earth, Pin 1 : Neutral
Fusing: Internal fuse (F1): F15AH, 250V fuse 6.3x32 mm.
Output Connections:
DC output +ve & -ve connection by two M6x18 studs, max torque 4.4Nm.
Use appropriate ring terminals and wire for the load and short circuit current.
Output Signals
Signal connections available on two 10-way 2.5mm header connectors (ref J2,J3).
Mating 10-way housing : Molex 22-01-1102.
Mating crimp terminals : 08 70 0064
Pinout :-
Note : Two shorting links (supplied) may be fitted at J2 or J3 to permanently enable the
3&4 and one link between pins 5&6 to permanently enable.
Fault Finding
If the unit shuts down, switch off or remove the supply as it could be that an over voltage or over temperature
condition has occurred. In the event of an over temperature condition, ensure the unit has cooled down before re-
applying the supply. If the unit still fails to power up, return to TDK-Lambda UK Ltd for investigation and repair.
Value
100 - 240 Vac
50-60Hz
8.2A rms
Output Current
(V) (A)
42
18
18
10.5
J2,J3 Pin
1
2
3
4
5
6
7
8
9
10
Maximum Power
(W)
504
504
504
504
Function
+ Sense
- Sense
COM
- remote on/off
+ remote on/off
Aux
Current share
Trim
ENA
IOG
Page 14 of 15
Fit one link between pins
PSU.
61006 issue 10, June 2014